About VoronLab
VoronLab covers the Voron CoreXY printers: choosing between V0, Trident, 2.4 and Switchwire, sourcing and build sequence, Klipper configuration and input-shaper resonance tuning, Stealthburner toolhead assembly, and CAN bus wiring.
It is written for people part-way through a Voron build who need the next decision to be the right one. Sources are the Voron design documents, Klipper documentation and component datasheets.
Alongside the articles there is one interactive tool: the Klipper input shaper and CoreXY speed calculator, which turns measured X and Y resonance frequencies and a hotend flow limit into a shaper type, an acceleration ceiling and a printer.cfg snippet.
What is covered here
- Buying Guides
- Firmware
- Klipper Tuning
- Sourcing
- Voron Builds
6 articles are published so far. New articles are announced on the RSS feed; there is no fixed publishing schedule and this site does not promise one.
How these articles are produced
Articles are researched from primary sources: vendor and project documentation, published standards and specifications, release notes, advisories, and measurements published by the people who took them. Drafts are produced with AI assistance and then edited against those same sources before anything is published. Where a figure comes from a datasheet or a third-party measurement, the article names the source and links to it so you can check the original rather than take this site's summary of it.
Everything here is published under the VoronLab Editorial byline. That is an editorial desk, not a person, and no article on this site claims hands-on lab testing, benchmarking, or first-hand measurement. Nothing here should be read as a report of something this site physically tested.
Corrections
Getting it right matters more than getting it first. If something on this site is wrong, out of date, or missing the source it should cite, email hello@voronlab.com with the page and the specific claim. Substantive corrections are made on the page itself rather than quietly dropped.
How this site is funded
Some links to products on this site are Amazon affiliate links, and as an Amazon Associate this site earns from qualifying purchases. The commission is paid by Amazon and does not change the price you pay, and any article containing such a link says so at the top of the page. There is no sponsored content, no paid placement, no display advertising and no newsletter sponsorship, and no vendor has any influence over what is written here or how it is rated.
The full position is on the disclosure page. Read it before acting on anything here that reads like a buying recommendation.
Related sites
VoronLab is run alongside a small number of other single-topic sites:
- SlicerGuide - Master your slicer settings.
- ResinPrintGuide - Mastering SLA Resin 3D Printing & Wash/Cure Tuning.
- Bambu Reviews - X1-Carbon, P1S and A1 Specs Compared
Contact
Email: hello@voronlab.com
Site: voronlab.com
Privacy: privacy policy ·
terms of use